Programmable digital meter

Programmable digital meter

N30U – Programmable digital meter of temperature, resistance, and standard signals

  • Input:
    • temperature:
      • resistance thermometers: Pt100, Pt500, Pt1000
      • thermocouples: J, K, N, E, R, S
    • resistance: 400 ohm, 4000 ohm
    • current: ± 20 mA
    • voltage: 0…10 V, -10…60 mV
  • Output: relay (4), analog (1), digital RS-485/MODBUS (1),
  • Three-colour display – red, green and orange, programmable in three intervals of the measured value – facilitates the observation of measured value changes.
    • digit height: 14 mm
    • highlighted measuring unit
  • Four alarm outputs with signaling on LED diodes operating in six different modes.
  • Conversion of any measured value into an analog signal: 0/4…20 mA or 0…10 V.
  • Storage of minimal and maximal values for all measured quantities,
  • Mathematical functions – avalaible from 2.04 version
  • Meter programming from the keyboard or through the RS-485 interface by means of the free eCon software
    One can reprogram following parameters:
    • display colour, individually in three intervals,
    • thresholds of displayed overflows,
    • display precision of the result (decimal point),
    • unit highlighting,
    • measurement averaging time,
    • recount of indications (individual characteristic),
    • parameters of alarm outputs.
  • Supply: 85…253 V a.c./d.c. or 20…40 V a.c./d.c.
  • Casing protection grade : IP65
  • Overall dimensions: 96 x 48 x 64 mm 
Print Friendly, PDF & Email
Close Menu